SATO CX400 - Print Length, Expanded

Section 2: Command Codes
Page 2-46 PN 9001106 Rev. A SATO CX400
Print Length, Expanded
Command Structure <ESC>EX0 Sets the print length to 40” (1015 mm))
<ESC>AR Resets the maximum print length to 7" (178 mm)
Example: See above
Placement: Must follow the Start Code command and be in it is own
separate data stream.
Default: <ESC>AR(7”)
Command Function To increase the maximum print length (in feed direction) for a label.
Input to Printer <ESC>A
<ESC>EX0
<ESC>Z
<ESC>A
<ESC>H0050<ESC>V0100<ESC>WB1EXPAND TO:
<ESC>H0050<ESC>V2700<ESC>WB1MAX INCHES
<ESC>Q1<ESC>Z
<ESC>A
<ESC>AR
<ESC>Z
Printer Output
SPECIAL NOTES 1. EX0 is effective until AR is sent to reset the printer to its standard
print length, or until the printer is re-powered.
2. When this command is used with the <ESC>& Store Form Overlay
command the Form length cannot exceed the maximum specified.
3. If a job contains elements out of the memory range, it is ignored.
4. If the Forms Overlay command <ESC>& is used with Expanded
Memory to expand the print area, the Form Overlay length is still lim-
ited to the maximum.