The Receiver should be assembled in such way that the operator can easily check
the indications given from the units LED-display.
The Receiver shall not be mounted in a place where the temperature can increase over max
specied temperature.
The antenna must never touch a metal object and should not be mounted
in an area that is surrounded by metal as it causes reections that signicantly
reduce range. Keep the antenna at a distance of at least 10 cm from metal objects if possible.
Optimal range is achieved if the Transmitter and antenna are within line-of-sight.
Important during welding!
During electrical welding on machine all connectors from the Receiver must
be disconnected. Ignoring this may damage the Receiver and void warranty.
24/33
To Next Page
Loading...
