Schaerer Barista - Brewing Sieve Rinsing

56
Schaerer Barista operating instructions
Care | Cleaning programmes
When switching OFF after cleaning
* Tap on Yes
Without switching OFF after cleaning
* Tap on No
* Remove the portalter
* Remove the brewing sieves from the portalters
* Insert the blind sieves into the portalters
* Insert one 1.3 g Schaerer special cleaning tablet
into each portalter
Note: Do not add water.
* Insert the portalter.
The question of whether cleaning should be
continued appears.
* Conrm with
and continue
The question of whether cleaning tablets are
inserted appears.
* Conrm with
and continue
The cleaning process starts. A bar graph and the
remaining time are displayed.
After about 9 minutes, an animation plays,
instructing the portalter to be removed and the
sieve changed.
* Remove the portalter
* Remove the blind sieve
Do not yet insert the portalter. The brewing sieve is
rinsed.
* Conrm with
and continue
An instruction to manually clean the portalters and
the sieve appears.
* Conrm with
and continue
If Yes is selected for cleaning with switch off, the
machine switches off now.
If No is selected for cleaning without switch off,
the coffee machine heats back up.
The coffee machine is now ready for use.
6.3.2 Brewing sieve rinsing
w Operation w Rinsing brewing sieve, page 26
The programme always
cleans both brewing groups
together, even if only one
was in operation. If a brewing
group was not used, it is not
necessary to insert cleaning
tablets into this portalter. The
blind sieve must be inserted in
both portalters.
8:03
DI _R al _12
Manually clean the portalter
and sieve.
w Cleaning the portalter
page 58
Manually cleaning the brewing
sieve
wCleaning portalter
page 58