Schindler 3300 - Page 109

Schindler 3100/3300/6300 J 43402603 / 01 109/269
Copyright © 2017 INVENTIO AG
VARIDOOR35 Error Codes
0x3D 61 CAN Tx COB Id_Collision
0x3E 62 CAN PDO length too short
0x3F 63 CAN bus off
0x40 64 CAN Rx queue overflow
0x41 65 CAN Tx queue overflow
0x43 67 Position following
0x44 68 Hall sensor
0x45 69 Index processing
0x46 70 Encoder resolution
0x4A 74 Hall angle detection
0x4B 75 Software position limit
0x4C 76 Position sensor breach
0x4D 77 System overloaded
ID Possible Causes Actions to be taken
1
0x2A 42 NGT 24 VDC over 10 % Limit
0x2B 43 NGT 24 VDC under 10 %
Limit
Power supply voltage out of range
Replace power supply
2
0x31 49 over current
Too high controller gains (velocity
control parameter set, position control
parameter set)
Run autosetup
3
0x31 49 Over current
Profile acceleration and/or
deceleration too high
 Run autosetup
 Reduce parameter
39_speed_close and 40_speed
open
4
0x32 50 Over voltage
Too much energy is fed back from the
motor during a deceleration phase
 Run autosetup
 Reduce parameter
39_speed_close and 40_speed
open
5
0x32 50 Over voltage
The power supply is damaged
Replace power supply
6
0x32 50 Over voltage
Oscillation of the mechanical system
(mass/belt) that leads to energy
pulsation of energy
 Check belt tension
 Run autosetup
7
0x38 56 Software internal parameter
Extreme motion profile parameters
 Check if a parameter was changed
recently. If yes, change it back to its
default value
 Run autosetup
8
0x38 56 Software internal parameter
At startup the parameters are
corrupted
 Set the parameter Nr. 169
SetParamToDef to value
 Run autosetup
 If no success replace DDE-VD35
HEX DEC Error