134 • Schlage • L-Series service manual
Ordering procedures
Ordering procedures
To order Schlage products, descriptive data should be in the same sequence as shown:
Line
Item
Qty Product Outside Inside Hand Latch Strike DR
THK
EXT DIM Additional Details
DES FIN DES FIN
1 2 3 4 5 6 7 8 9 10 11 12 13 14
1. Line Item: Line item number
2. Qty: Quantity
3. Product: Complete lock product or part number
4. Outside DES: Outside design code
5. Outside FIN: Outside finish code
6. Inside DES: Inside design code: Leave blank if same as
outside design code.
7. Inside FIN: Inside finish code: Leave blank if same as
outside finish code.
8. Hand: Hand of door: Only one hand allowed per line item.
Example: RH=Right Hand, LH=Le Hand,
RR=Right Reverse, LR=Le Reverse
9. Latch: Latch: Leave blank for standard or specify part
number if non-standard latch is required. LLL=Less
Latch.
10. Strike: Strike: Leave blank for standard or specify part
number if non-standard strike is required. LLL=Less
Strike.
11. DR THK: Door thickness: Enter door thickness if non-
standard. Example: 138=1C\,’’, 214=2Z\v’’, 212=2Z\x’’.
12. EXT: Extension: Enter one of the following when doors 2’’
thick or greater are specified: EE=Extended Equally,
EI=Extended Inside, EO=Extended Outside,
ED=Extended Differently. EI or EO assumes the latch will
be
centered on a 1C\v’’ door, to which material has been
added.
13. DIM: Dimension: Enter dimension for non-standard strike
lip length and mortise cylinder or blocking ring length.
012 = Z\,” 037 = C\,” 118 = 1Z\,” 158 = 1B\,”
018 = C\zn” 050 = Z\x” 114 = 1Z\v” 134 = 1C\v”
025 = Z\v” 078 = M\,” 138 = 1C\,”
200 = 2”
031 = B\zn”
100 = 1”
112 = 1Z\x”
400 = 4”
14. Additional Details: Enter detail for keying information
and for special requirements.
15. Examples:
Line
Item
Qty Product Outside Inside Hand Latch Strike DR
THK
EXT DIM Additional Details
DES FIN DES FIN
One mortise cylinder, 1Z\v” long, which will operate a Von Duprin exit device.
17 1 20-001 626 114
One hotel function L-Series lock with 17B trim in 625 for le hand door.
18 1 L9485P 17B 625 LH 114
Five replacement inside L escutcheons with “EZ” turn, in satin stainless steel, to be used with 06 lever on 1C\v” doors.
19 5 09-633 06L 630 134 with EZ turn
per L583-363
To Next Page
