Date Code 20010518 Commands 5-9
SEL-2020 Instruction Manual
DNPMAP (Access Level 1)
The DNPMAP command displays a map of the data available to DNP, including object type,
index, and default variation. This map is based on the port and math settings on port 16. Event
objects will not be displayed; event objects will have the same indexes as their corresponding
static object. See Appendix I: Distributed Network Protocol (DNP )V3.00 for more
information.
*>>DNPMAP<ENTER>
DNPMAP<ENTER>DNPMAP<ENTER>
DNPMAP<ENTER>
Date: 03/03/95 Time: 15:06:06
DNP Address: 0000h
Object Type Index Default Variation Label
01 0-47 02 1:TARGET:TARGET
20 0-2 06 1:LOCAL:ARCHIVE_CNTRS
30 0 03 1:METER:IA(A)
30 1 03 1:METER:IB(A)
30 2 03 1:METER:IC(A)
30 3 03 1:METER:VA(V)
30 4 03 1:METER:VB(V)
30 5 03 1:METER:VC(V)
*>>
HELP (Access Level 0)
The HELP command lists all commands available at the current access level with a one-line
description of each, as shown in the display below. Use the HELP command with another com-
mand as its parameter and it will provide the syntax and a brief description of the command. If
you use the HELP command with an invalid command parameter, the SEL-2020 responds with
an error message.
*HELP<ENTER>
*HELP<ENTER>*HELP<ENTER>
*HELP<ENTER>
Commands available at current access level:
- ACCESS - Change access level to Access Level 1
- HELP - Provide information on available commands
- ID - Display SEL-2020 identification information
- QUIT - Change access level to Access Level 0
*
To Next Page
