34
Installation
Type 024.16.720
Fig. 18: Installing the switch spindle
→ Press the O-ring downwards into the cover of the actuator.
→ Screw the guide piece into the cover of the actuator using a face wrench
1)
(torque: 8.0 Nm).
→ To secure the switch spindle, apply some screw locking paint (Loctite 290) to the thread of the switch
spindle.
→ Push the puck holder onto the switch spindle until it engages.
1)
journal Ø: 3 mm; journal gap: 23.5 mm
2. Install positioner
→ Push the positioner onto the actuator. The puck holder must be aligned in such a way that it is inserted
into the guide rail of the positioner.
Guide rail
Puck holder
Fig. 19: Aligning the puck holder
→ Press the positioner all the way down as far as the actuator and turn it into the required position.
Puck holder
Spindle extension
Guide bushing
O-ring
To Next Page
Loading...