Seltron ST2 - Program group P1

Program group P1
Program group P1 is used for the thermostat user settings. To
change the selected parameter, hold key for approximately 5
seconds. Parameter starts to flash. Press key ( ) or ( ) to
set the parameter value. To store the setted value, again hold
key for approximately 5 seconds.
Group P1 contains the following parameters; (factory setting):
- [P1.1]
- [P1.2] - (-
- [P1.3]
- - - deactivated, P - temp. is setted with the knob);
- [P1.4]
- [P1.5] - - - deactivated); (20 min)
- [P1.6] Display of controlled device (- - - none, 1 - oil boiler,
2 - gas boiler, 3 - actuator, 4 - pump); (1)
- [P1.7] Temperature sensor calibration (-
- [P1.8] - - - inactive); (- - -)
- [P1.9] Periodic activation of pumps and mixing valve
(- - - deactivated, 1 - activated)
1
; (1)
1
Activation is every Saturday at:
21:01 - mixing valve or circulation pump activation
21:02 - d. h. w. circulation pump activation
This procedure, for modifying the parameter, is the same
for all program and service groups.
i
SETTING MANUAL
23