SETTING MANUAL
Program group P2
In program group P2 are the following parameters;
(factory setting):
- [P2.1]
- [P2.2] Switch-on hysteresis for domestic hot water
- [P2.3]
- [P2.4] M
- [P2.5] Naximal stand-
- [P2.6]
- [P2.7] Beeper mode (- - - silent, 1 - by typing, 2 - by program
Timer changeover, 3 - by typing and program timer
changeover); (1)
- [P2.8] (1)
- [P2.9] Radio module type (1 - AM module, 2 - FM module); (1)
- [P2.10] Display of measured temperatures (1 - built in sensor,
2 - auxiliary sensor, 3 - both sensors - alternating,
4 - display of requested (setted) temperature,
5 - return-pipe temperature sensor); (1)
- [P2.11] (2 min)
- [P2.12]
Program group P3
Program group P3 is intended to set the remote control with tele-
phone. In program group P3 are the following parameters; (factory
setting):
- [P3.1] P - temperature
setted with the knob); (P)
24
To Next Page
Loading...
