Service group S3
program group S3 are the following parameters:
- [S3.1] Group locking (- - - no locking,
1 - locked are groups S,
2 - locked are groups S and P,
3 - locked complete menu); (1)
Picture 24
1
Parameters S2.8, S2.9 and S2.10 are intended only for heating
circuit with 3 point control.
i
Access to parameter S3.1 is possible in the following way. Hold
key for 20 seconds (picture 24). Release the key after you
possible to modify this or any other parameter.
SETTING MANUAL
27
To Next Page
Loading...
