OmniHub CMP203– User Manual
Page 75 of 109
Symbol rate. The STB “Autosearch Setup” or setting should have the same parameters
for Frequency and Symbol rate.
One important information we need is to know what frequency and what TS we will
create the Cable Descriptor. Once we know what frequency, we need to create the TSID
that we are currently using. If we have 4 frequency output on the Network, we need to
create 4 TSID as shown below. Just input the correct Frequency on each TS and add.
Repeat the procedure once all Frequency are added.
For the LCN or Logical Channel number. This created the same way with Cable
Descriptor. On 1 frequency, you will Add NIT Stream and create multiple TSID. Here
you will add the LCN on each TSID.
To Next Page
Loading...