3.2.6 Keyboard
1. Activate the Main Menu by pressing
2. Select the menu "System Settings" by going down in the menu using
3. Activate the selection by pressing
4. Select the item "Key Click" by navigating through the menu using or
5. Activate the selection by pressing once.
6. Adjust the volume of the Key Click by using the UP and DOWN Button.
When the Key Click is ON you hear a beep when pushing a button.
7. Push the Display Button twice to exit the menus.
8. If you push the AUDIO PAUSED / OFF Button the AUDIO PAUSED / OFF
Button Indicator (yellow LED) should light up (note: if the parameter “Alarm
Volume” is set to OFF pressing the AUDIO PAUSED / OFF Button has no function).
If the above described functions do not operate properly contact your local SenTec
representative or return the monitor according to
section 8.6 "Instructions for
Shipment”.
For SenTec authorized service technicians only: If the above requirements
for the Keyboard are not fulfilled then replace the SDM Case, upper part according
to the
Repair Manual for the SDMS
(HB-005755).
3.2.7 Clock Settings
Verify that the clock settings are correct. If necessary, adjust the clock in the SDM
Menu "System Settings Date / Time".
Power cycle the SDM and control the clock settings.
If the clock settings are not correct refer to
section 4.2.4 "SDM specific
troubleshooting"
to further evaluate the problem.
To Next Page
Loading...
