41
Take 5 User’s Guide
Effects
To add an Effect:
1. Press the effect on/off button to turn it on.
2. Turn the
type knob to select an effect. The effect name is shown in the
lower right of the main display. Names are abbreviated. For instance
“bbd” is the bucket-brigade delay. Refer to the previous list.
3. Turn the
depth/mix knob clockwise to blend in the processed signal.
4. Use the
time and feedback/misc knobs to adjust effect parameters. Refer to
the chart to see which parameters each of these knobs control
To add Reverb:
1. Press the reverb on/off button to turn it on.
2. Turn the mix knob clockwise to blend in the processed signal.
3. Use the
decay knob to adjust the length of the reverb tail.
4. Use the
pre-delay knob to adjust the pre-delay.
5. Use the
tone knob to shape the frequency content of the reverb. The tone
parameter uses both high-pass and low-pass ltering to sculpt the reverb’s
sound.
6. Use the
damping knob to adjust reverb damping (absorption of the high
frequencies of the reverb). Less damping allows high frequencies to decay
slower to create a brighter reverb sound. More damping darkens the sound
of the reverb.
To Next Page
Loading...
