The battery life of the remote key is about one year.
When the battery power is low, the instrument will
display "low key battery power".
Please follow the below steps to replace the battery：
1. Place the remote key on a soft surface with the button side
down.
Illustration：Remove the mechanical key
2. After pressing the release button, pull out the mechanical
key.
Illustration: open the rear cover of the key
3. Use a small flat bladed tool to open the key rear housing.
Illustration: remove the remote key battery
4. Using a small flat bladed tool, pry the battery
up from the edge of the battery.
5.
Insert a new battery (model: CR2032) with the
"+" side facing upward. Avoid touching the battery
surface. Finger marks may reduce the service life of
the battery. Clean the battery surface before
installation.
6. Install the key rear cover and press it tightly.
7. Insert the mechanical key.
8. Operate the remote key button (such as
unlocking the vehicle, locking the vehicle, opening
the back door, etc.), and check and confirm that the
remote key works normally.
The replaced battery is very small and may cause
suffocation if swallowed by children. Please keep the
battery out of the reach of children, otherwise it may
cause serious injury or even death.
Please dispose of waste batteries according to
local regulations. Incorrect disposal methods
of waste batteries will damage the
environment and endanger human health.
To Next Page
Loading...