Glass washing solution
The vehicle has only one reservoir to fill. The
windshield washer fluid reservoir is on the right side
of the front engine compartment. When the liquid
level is low, fill it until the liquid level just reaches
below the filler. Do not use the prepared windshield
cleaning fluid, which contains waterproof agent or
insect repellent glass water. These fluids may cause
stripes and stains on the windshield, squeak or other
noise when the windshield is brushed. Operate the
scrubber regularly to check whether the nozzle is
blocked and whether it can spray correctly.
• Do not splash the windshield washer fluid on the
body panel, otherwise it may cause damage. Wipe
the spill immediately and clean the spilled part
with clean water.
• When the temperature is lower than 4 ° C, use
windshield washer fluid containing antifreeze. In
cold weather, using windshield washer fluid without
antifreeze will reduce the visibility of the
windshield.
Some national or local regulations restrict the use
of volatile organic compounds (VOCs) which are
usually used as antifreeze in windshield cleaning
fluid. Windshield cleaning fluid containing
restricted VOCs can only be used if it needs to have
sufficient frost resistance in various climatic
conditions of driving vehicle.
According to different seasons, mix water with
corresponding additives (window cleaner concentrate,
antifreeze), always use the correct mixing ratio and read all
instructions on the container of additives used.
● Summer: fill with water and window cleaner concentrate.
● Winter: fill with water, antifreeze and window cleaner
concentrate.
Figure: water filling cover plate of washing pot
1. Open the water filling cover of the washing pot
on the right side of the engine room.
2.
Before opening the tank cover, clean the tank
cover to prevent dust from entering the reservoir.
Figure: water inlet of washing kettle
3. Open the tank cover.
4. Fill to the proper position as required.
5. Cover the tank..
To Next Page
Loading...
Need help?
General