SERES SF5 - Vehicle Connectivity; Bluetooth Compatibility and Pairing

Connection
The vehicle can transmit data in different ways, but all data
transmission of the vehicle can only be connected through one
device at the same time.
Bluetooth® compatibility
If the mobile phone is in the operating range, you can use a mobile phone
with Bluetooth communication function in the vehicle for hands-free
use.
Before using the mobile phone with the vehicle, it must be paired. Pair
the vehicle with a Bluetooth-enabled mobile phone.
If the system storage of connected devices has reached the upper limit, if
you want to add a mobile device, you must delete a paired device first.
When pairing, you need to set the vehicle to use with a mobile
phone with Bluetooth function. After the mobile phone is
successfully paired, as long as the mobile phone turns on the
Bluetooth and is within the vehicle's Bluetooth signal range,
the vehicle can establish a connection with the mobile
phone.
To pair a mobile phone, follow the steps below while sitting in
the vehicle:
1. Make sure that both the touch screen and the phone are
turned on.
2. Enable Bluetooth in the system settings.
3. Turn on Bluetooth on the phone and set it to be visible.
4. Tap to start searching on the touch screen, touch the
screen to search, and then display a list of all available
Bluetooth devices within the detection range.
5. Tap the phone to be paired on the touch screen. Within a
few seconds, the touch screen will display a randomly
generated number, and the phone will display the same
pairing number.
6. Check that the number displayed on the phone matches
the number displayed on the touch screen. Then confirm
the pairing on the mobile phone.
Attention
If the phone battery is low, Bluetooth will turn off.
Illustration: Settings> Connection (Different configuration
functions are different, please refer to the actual vehicle)
1 Bluetooth: Click the button, the Illustration lights up
to indicate that the function has been turned on, and
expand the device to be connected. The button is
grayed out to indicate that the function has been turned
off.
2 WIFI: Click the button, the Illustration lights up to
indicate that the function has been turned on, and
expand the device to be connected. The button is
grayed out to indicate that the function has been turned
off.
C