Picture: Seat forward/backward/height adjustment button
1
Move the seat forward/backward and release the adjustment
button when it is adjusted to a suitable position.
2 Adjust the tilt angle of the seat up/down, and release the adjustment button
when it is adjusted to a suitable angle.
3 Adjust the seat height up/down, and release the
adjustment button when it is adjusted to a suitable
angle.
Picture: correct driving position
In order to protect your safety to the utmost extent, the seat, headrest,
seat belt and airbag must be used together. Proper use of these safety
devices can ensure better protection.
Adjust the seat position so that the seat belt is properly worn
while staying as far away from the front airbag as possible:
●
Sit upright with your feet on the floor and the seat back
should not tilt more than 30°.
● Make sure you can easily step on the pedals, bend your
arms slightly when holding the steering wheel, and leave
at least 25 cm between the chest and the center of the
airbag cover.
● Place the middle part of the seat belt between the neck
and shoulders, and wrap the overlapping part of the seat
belt tightly around the hip joint, not the abdomen.
The front seat slide rail is adjusted to the final
position, and the backrest is at an angle of 25°
from the vertical.
Picture: Backrest tilt angle adjustment button
Toggle the electric button for adjusting the angle of the outer backrest of
the seat back and forth. After the angle is adjusted to a suitable angle,
release the angle adjustment button.
To Next Page
Loading...