1. Before lifting the rear seat, make sure that the
seat belt is not stuck behind the backrest.
2.
Pull the seat back up until it locks into place.
3. Install the rear middle headrest.
• When the seat returns to its original
position, it must be confirmed that it is
securely fixed in the locked position. If it is
not completely locked, it may cause injury
during driving or sudden braking.
Picture: The unlocking device is located on the rear side of the outer rear
headrest
Both parts of the rear seat backrest can be folded separately to facilitate
the transportation of longer cargo.
• Do not apply a load exceeding 20kg on the folded seat
backrest.
• The rear seat cannot be folded while the vehicle is
driving, because when the vehicle decelerates or
accelerates suddenly, it may cause injury to the person
folding the seat.
• When there are passengers or luggage in the rear seat,
do not fold the corresponding rear seat.
• Properly secure luggage to prevent it from sliding or
moving, and do not place luggage higher than the seat
backrest.
• When the seat is in the folded position, no one is
allowed to ride in the luggage area or the rear seat.
Passengers who use these areas without proper
protection may cause serious injury while driving or
when braking suddenly.
• Be careful not to damage the seat belt when folding the
rear seats.
•
Before folding the seat back down, remove the
headrest and store it safely, otherwise the headrest
may be damaged.
Before folding the rear seats, it may be necessary to adjust the front
seats forward to fully fold the rear seats forward.
1.
Press the unlocking point to unlock it, and
then tilt the backrest forward.
To Next Page
Loading...