SERES SF5 - Gear Shifter Operation; Gear Shifting Procedures

Gear
Example：Gear shift knob
Please fasten your seat belts and keep the doors closed before
shifting gears.
When the vehicle is in the parking gear, the brake pedal
must be depressed to switch the gear.
Turn the shift knob to the left or right to change gears.
illustrate
If you try to switch to a gear that is prohibited by the current
driving speed, you will hear a knocking sound and the gear will
be not changed 。
● P gear into R gear, you need to turn the shift knob to the left
by two notches to the end. When shifting gears, press and hold
the brake pedal at the same time, and the accelerator pedal is in
the released state.
● N gear into R gear, turn the shift knob one click to the left.
When shifting, if the vehicle is at a standstill, the brake pedal
must be depressed and the accelerator pedal in the released
state.
● D gear into R gear, you need to turn the shift knob to the left
by two notches to the end. When shifting gears, the vehicle
needs to have no forward speed, and at the same time step on
the brake pedal, and the accelerator pedal is in the released
state.
● To shift P gear into N gear, you need to rotate the shifter one
step to the left or right, and you need to depress the brake pedal
when shifting gears.
● To shift R gear into N gear, turn the shift knob one click to the
right.
● To shift D gear into N gear, turn the shift knob to the left by one
click.
● Rotate the shift knob to the left or right to the first position and
release it to switch to neutral. The neutral position allows the
vehicle to move freely.
● P block into D block, the shifter needs to be rotated two
squares to the right, and the brake pedal should be pressed at
the same time when shifting, and the accelerator pedal should
be in the released state.
● When the R block enters the D block, the shifter needs to be
rotated two notches to the right. When shifting, the vehicle
must not be speeding backward, and the brake pedal must be
depressed at the same time, and the accelerator pedal must be
in the released state.
● When N block is in D block, the shifter needs to be rotated
one notch to the right. When shifting, if the vehicle is at a
standstill, the brake pedal needs to be depressed and the
accelerator pedal is in the released state.
● When requesting to enter P gear, press the P gear button, and keep
the vehicle at a standstill when shifting gears.
Notice
• When the vehicle is at a high speed, keep
pressing the P gear button to trigger the
dynamic parking function (refer to page 84).
To keep the vehicle in neutral at all times in order to
maintain free movement (for example, using a
transport vehicle to tow, etc.), please perform one of
the following methods:
● Release the parking brake.
● Enable dragged mode (refer to page 146).