EasyManua.ls Logo

SERES SF5 - Page 162

SERES SF5
204 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Please follow the following steps to temporarily repair
small tire punctures (diameter less than 6mm). For more
information, please read and follow the instructions on
the quick tire repair tool.
1. Drive the vehicle off the road to a safe place and
passengers to wait there.
2. Turn on the hazard alarm flash and set warning signs at safe
positions to avoid accidents.
3. If possible, place the tire puncture part at the bottom of
the wheel as far as possible.
Figure: install tire repair rubber tank
4. Take out the tool kit, insert the tire repair fluid into the
opening of the inflation pump and press it firmly.
5. Remove the valve cap of the leaking tire air valve and
connect the transparent tire repair fluid pipe.
Figure: connect the power plug
6. Ensure that the charging pump start switch is off.
7.
Plug the power plug into the 12V power socket
on the vehicle to ensure that the vehicle is
unlocked, the door is opened, and the instrument
touch screen is on.
Figure: start the inflation pump
8.
Press the switch button to start the inflation pump.
After about 10 minutes or when the tire pressure
reaches 2.5 bar, the tire repair fluid will completely
flow into the tire.
Attention
If the pressure gauge still shows that the tire pressure is
lower than 1.3bar/19psi 15 minutes after the inflation
pump is started, please turn off the inflation pump,
disconnect the open tire fluid pipe, remove the tire fluid,
start the vehicle tire, after rolling for about 5 circles, the tire
fluid in the tire will be evenly distributed into the tire, stop
and turn on the electronic parking to inflate the tire. If the
tire pressure is still lower than 1.3bar/19psi after 15
minutes, it indicates that the tire is seriously damaged and
cannot be repaired urgently. Please take the tire repair tool
back into the vehicle for storage and call road rescue.
9.
Press the switch button, turn off the inflation pump,
disconnect the open tire repair fluid pipe, remove the tire
repair fluid tank, and screw on the valve cap of the tire air
valve.

Table of Contents