Long press (manual mode) and short press (automatic
mode), short press time ≤ 250ms, long press time >
250ms.
1
• Press briefly to close the sunroof glass
completely
•
Long press to close the sunroof glass and release
to pause.
2
•
Press briefly to fully open the sunroof glass and
open the sun blind in linkage.
•
Press and hold, the sunroof will open, and the
linkage between the glass and the sunshade will be
suspended.
3
• Press briefly to close the sunroof blind
completely.
•
Long press to close the sunroof blind, and
release to pause
4
•
Press briefly to fully open the sunroof blind.
•
Press and hold to open the sunroof blind, and
release to pause
。
5
•
The sunroof and sunroof blind can be opened
to the ventilation position to ventilate the air in
the vehicle.
This vehicle has the function of opening / closing
the sunroof with the remote key.
If the panoramic sunroof or sunroof blind are
suddenly blocked during closing, it will stop closing
and move slightly in the opposite direction and stop.
If it is found that the wind noise is too loud after the
sunroof is opened (depending on the driving speed), you
can open one window slightly. If the sunroof encounters
an obstacle during the closing process, the anti pinch
function will be triggered, and the sunroof or sunshade
will move slightly in the opposite direction and stop. If it
is unsuccessful to close again after removing the
obstacle, press and hold the close button "" on the
control panel, to force the sunroof to close.
。
When the panoramic roof and sunroof blind cannot work
normally, perform the initialization of panoramic sunroof
according to the following steps:
1.
Start the vehicle, close the panoramic sunroof and
sunroof blind, press and hold the panoramic sunroof
button or sunroof blind button in the forward
direction of the vehicle for more than 6s until the
fully closed position stops (the button cannot be
released at this time, otherwise initialization fails).
After completion, initialization of the sunroof and
sunroof blind are completed, The function can be
confirmed by operating the sunroof button and the
sunroof blind button
。
2. Release the button.
3.
Operate the sunroof button close gear again
within 6S and keep it for 4S, the sunroof glass will
tilt / slide open, and the sunroof blind will also
move in the opening direction. After the sunroof
glass is fully opened, the sunroof glass will start to
close. After the sunroof glass is closed, the
sunsroof blind will start to close.
4.
Fully close, release the button, and the initialization of
panoramic sunroof is completed.
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...