SEW-Eurodrive MFE Series - Startup Procedure

7
Startup
Startup procedure
Manual – EtherCAT
®
Interfaces, Field Distributors
67
INFORMATION
• Switch off the DC 24 V voltage supply before removing/installing the fieldbus inter-
face.
• The incoming and outgoing PROFINET IO bus cables are connected to the
module electronics. If the module electronics are removed, the PROFINET IO line
is interrupted.
• In addition, observe the notes in chapter "Supplementary Field Distributor Startup
Information" of the manual.
7.2 Startup procedure
INFORMATION
This chapter describes the startup procedure for MOVIMOT
®
MM..D in Easy mode.
For information on the startup of MOVIMOT
®
 MM..D in Expert mode, refer to the
"MOVIMOT
®
MM..D" operating instructions.
WARNING
Electric shock from capacitors that have not been fully discharged.
Severe or fatal injuries.
• Disconnect the inverter from the power. Observe the minimum switch-off time
after disconnection from the supply system:
– 1 minute
1. Make sure the MOVIMOT
®
inverter and the EtherCAT
®
interface (MFZ21, MFZ23,
MFZ26, MFZ27 or MFZ28) are installed correctly.
2. Set the S1/1 DIP switch on the MOVIMOT
®
inverter (see relevant MOVIMOT
®
op-
erating instructions) to "ON" (= address 1).
1
ON
6
7
8
543
2
1
ON
2
1158400267
3. Remove the screw plug above the f1 setpoint potentiometer on the MOVIMOT
®
in-
verter.
4. Set the maximum speed using setpoint potentiometer f1.
123456789100
100
f[Hz
[1]
]
2
75
25
50
6
5
f
1
1158517259
25809148/EN – 01/2019