11
SETUP
1
9
Select "Connected to this computer"
and click the "Next" button.
Follow the on-screen instructions.
When "The installation of the SHARP software is
complete." appears, click the "OK" button.
10
You will return to the window of step 8.
If you wish to install Button Manager,
click the "Button Manager" button.
If you do not wish to install the Button Manager,
go to step 11.
Follow the on-screen instructions.
11
When installing is finished, click the
"Close" button.
A message will appear instructing you to connect
the machine to your computer. Click the "OK"
button.
12
Connect the machine to your
computer with a USB cable.
(1) Make sure that the machine is powered
on.
(p.37)
(2) Connect the cable to the USB connector
(B type) on the machine.
The USB interface on the machine complies
with the USB 2.0 (Hi-Speed) standard.
Please purchase a shielded USB cable.
(3) Connect the other end of the cable to the
USB connector (A type) on your
computer.
If a warning window regarding security is
displayed, please click "Install this driver
software anyway" or "Install".
After the installation, a message prompting
you to restart your computer may appear. In
this case, click the "Yes" button to restart your
computer.
After the installation, a message prompting
you to restart your computer may appear. In
this case, click the "Yes" button to restart your
computer.
Note
To Next Page
Loading...
Need help?
General
