Sharp AR-7024D User Manual

95
USER SETTINGS
6
*
1
When the RSPF is installed.
*
2
When the 500-sheet paper feed units are installed.
*
3
When the network expansion kit is installed.
*
4
When pressed [CLEAR ALL] key( ), exceeding the auto clear time, resumed auto-power shut-off mode , or power on and
off, the paper type on bypass tray will resume to plain paper.
30
Use close
paper size
0: OFF
1: ON
• When this function is enabled, printing in printer
mode will automatically continue using a different size
of paper if the specified size of paper runs out in all
trays. This feature does not function in copy mode.
31
Default tray
setting
1: Tray1
2: Tray2
*2
3: Tray3
*2
4: Tray4
*2
5: Bypass tray
• Use this program to select a default tray. This tray is
automatically selected each time the power is turned
on or each time the machine reverts to the initial
settings.
32
Default
exposure mode
1: AUTO
2: TEXT
3: PHOTO
• Use this program to set "AUTO", "TEXT", or "PHOTO"
as the default exposure mode.
33
USB 2.0 mode
switching
1: Full-Speed
2: Hi-Speed
• This sets the USB 2.0 data transfer speed. If your
computer is not compatible with USB 2.0 (Hi-Speed),
use this program to change the USB 2.0 mode to
"Full-Speed".
34
Sort auto
select
*1
1: OFF
2: Sort
3: Group
• Use this setting to select the default output mode for
copying from the RSPF.
35 ID card
1: Pattern 1
2: Pattern 2
• Use this setting to copy the front and back sides of ID
card onto a page, and to use margin shift feature.
36
Auto power
shut-off
switching
immediately
after print job
finishes
0: OFF
1: ON
• This function automatically switches the machine to
auto power shut-off mode immediately after a print
job finishes.
If "OFF" is set, the duration of time for the Auto power
shut-off timer set in the program number (3) is
enabled.
37
IP ADDRESS
SETTING
*3
ENABLE DHCP
- YES
- NO
• If "YES" is selected (factory default setting) and the
machine is connected to a TCP/IP network, the IP
address will be acquired automatically. This is the
factory default setting.
If you will manually assign an IP address, select "NO".
For the detailed procedure, see
"ENABLING/DISABLING DHCP" (p.97).
IP ADDRESS
SETTING
-IP ADDRESS
-SUBNET MASK
-
DEFAULT GATEWAY
• This program is used to set the IP address (IP
address, Subnet Mask, and Gateway) of the machine
when TCP/IP protocol is used on the network.
For the detailed procedure, see "SETTING THE IP
ADDRESS" (p.98).
38
Status display
pattern
switching
1: Pattern 1
2: Pattern 2
• This sets the display pattern of the data notification
indicator ( ).
39
The number of
ID Card copy
setting
1: Single
2: Multi
• This function is used to set the number of copies
when copying ID card.
40
The memory
method of
paper type on
bypass tray
settings
0: Memory
1: No memory
*4
• This function is used to set the paper type on bypass
tray.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation

Sharp AR-7024D Specifications

General

Brand	Sharp
Model	AR-7024D
Category	All in One Printer
Language	English