Sharp MX-C312 User Manual

1-84
BEFORE USING THE MACHINE
Contents
CONNECTING THE MACHINE
CONNECTING TO A NETWORK
To connect the machine to a network, connect the LAN cable to the machine's network connector. Use a shielded LAN
cable.
After connecting the machine to a network, be sure to configure the IP address and other network settings before
installing the software. (The factory default setting for the IP address is to receive the IP address automatically when the
machine is used in a DHCP environment.)
Network settings can be configured using "Network Settings" in the system settings (administrator) on the machine.
X Checking the IP address of the machine
You can check the IP address of the machine by printing out the "All Custom Setting List" in the system settings. Follow
these steps to print out the "All Custom Setting List".
Press the [SYSTEM SETTINGS] key, touch the [List Print (User)] key, and then touch the [Print] key of "All Custom
Setting List".
CONNECTING THE MACHINE WITH A USB CABLE (Windows)
The machine can be connected to a computer using a USB cable if the computer is a Windows computer. (The USB
interface on the machine cannot be used in a Macintosh environment.)
The machine and computer should be connected while the printer driver is being installed. If a USB cable is connected
before the printer driver is installed, the printer driver will not be installed correctly. For the procedure for connecting a
USB cable, see "WHEN THE MACHINE WILL BE CONNECTED WITH A USB CABLE" (page 1-95).
• If the machine is used in a DHCP environment, the IP address of the machine may change. If this happens,
printing will not be possible. This problem can be avoided by using a WINS server or by assigning a permanent IP
address to the machine.
• This manual explains how to set up the software in a Windows network environment.
• To use the machine on an IPv6 network, the IPv6 setting must be enabled in "Network Settings" in the system
settings (administrator).

Sharp MX-C312 Specifications

Power

power consumption	1.44 kW or less
power source	AC 100-127VAC, 60HZ, 12 AMPS

Copying Features

copy speed	31 ppm B&W/Color
first copy time	8.0 sec or less (B&W); 8.9 sec or less (color)
warm-up time	90 seconds or less

Scanning Features

scan speed	Up to 35 ipm (B&W or color)
optical resolution	600 dpi
output modes	600 dpi, 400 dpi, 300 dpi, 200 dpi, 100 dpi

Network Printing System

print resolution	1200 dpi, 600 dpi
print speed	31 pages per minute (Letter)
resident fonts	80 Outline Fonts

Inner Finisher

output capacity	Up to 280 sheets (Letter/Legal)
weight	Approx. 19.8 lbs
dimensions	18-2/3" (w) x 13-1/16" (d) x 6-3/16" (h)

Weight and Dimensions

weight	102 lbs
dimensions	22-3/64" x 17-1/4" x 28-7/64"