7-75
SYSTEM SETTINGS
Contents
Auto Colour Calibration
This is used to perform automatic colour correction when the colour copy or print output appears to contain the incorrect
colours throughout the document. The machine prints a test patch, the test patch is scanned, and the colour is
automatically corrected.
After the [Execute] key is touched and a test patch is printed, a message appears prompting you to begin automatic
calibration. Place the test patch on the document glass as shown below (the four squares should be on the left).
Lay copy paper (about five sheets) that is the same size as the test patch on top of the placed test patch, gently close
the automatic document feeder, and touch the [Execute] key.
• Before executing Auto Colour Calibration, check to see if the registration adjustment is correct. If the registration
adjustment is not correct, perform "Registration Adjustment" (page 7-65).
• If the colour is still off after performing Auto Colour Calibration, repeating Auto Colour Calibration once again may improve
the colour.
Four squares
To Next Page
Loading...
