Sharp MX-C312

7-37
SYSTEM SETTINGS
Contents
Network Settings
Printer Settings
Item Factory default setting Page
■ Network Settings
7-72
● IPv4 Settings DHCP 7-72
● IPv6 Settings Disabled 7-72
● Enable TCP/IP Enabled 7-72
● Enable NetWare Enabled 7-72
● Enable EtherTalk Enabled 7-72
● Enable NetBEUI Enabled 7-72
● Reset the NIC – 7-72
● Ping Command – 7-72
Item Factory default setting Page
■ Printer Settings
7-73
● Default Settings 7-73
X Prohibit Notice Page Printing Enabled 7-73
X Prohibit Test Page Printing Disabled 7-73
X A4/Letter Size Auto Change Varies depending on country and region 7-73
X Print Density Level
7-73 Colour 3
 Black & White 3
X CMYK Exposure Adjustment 0 7-73
X Bypass Tray Settings 7-73
 Enable Detected Paper Size in Bypass Tray Disabled 7-73
 Enable Selected Paper Type in Bypass Tray Enabled 7-73
 Exclude Bypass-Tray from Auto Paper Select Disabled 7-73
X Job Spool Queuing Enabled 7-73
● Interface Settings 7-74
X Hexadecimal Dump Mode Disabled 7-74
X I/O Timeout 60 sec. 7-74
X Enable USB Port Enabled 7-74
X USB Port Emulation Switching Auto 7-74
X Enable Network Port Enabled 7-74
X Network Port Emulation Switching Auto 7-74
X Port Switching Method Switch at End of Job 7-74
● Auto Colour Calibration – 7-75