2-13
COPIER
Contents
3
Specify the original size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
When placing an AB (inch) size or non-standard size original, specify the original size as explained in "ORIGINAL
SIZES" (page 2-29).
4
Check the paper to be used and the
colour mode.
Make sure that the desired paper (tray) and colour mode are
selected.
• To change the paper (tray), touch the [Paper Select] key.
☞ PAPER TRAYS (page 2-9)
• To change the colour mode, touch the [Colour Mode] key.
☞ COLOUR COPY MODES (page 2-21)
For some original size settings, the same size of paper as the original may not be automatically selected. In this case,
manually change the paper size.
5
Set the number of copies (number of
sets) with the numeric keys.
• Up to 999 copies (sets) can be set.
• A single copy can be made even if "0" appears for the number of copies.
If an incorrect number of copies is set...
Press the [CLEAR] key ( ) and then enter the correct number.
6
Press the [COLOUR START] key or the [BLACK & WHITE START] key.
Normally copying will start.
Depending on the copy settings (2-sided copying, etc.), copying may not begin until all originals have been scanned. In this
case, go to the next step.
Even if a colour mode is selected, copying will take place in black and white if the [BLACK & WHITE START] key is
pressed.
None
Original
OK
A5
B5
Size Input
216x343
A4
216x330 16K
216x340
Custom Size
Inch
AB
(2)(1)
Colour Mode
Special Modes
Plain
2-Sided Copy
Output
File
Quick File
Copy Ratio
100%
A4
3.
2.
1.
A5
Original
Paper Select
Auto
A4
Plain
Full Colour
Exposure
Auto
A4
4.
A4
A4
A4
Plain
7
A4
Special Modes
2-Sided Copy
To Next Page
Loading...
