2-30
COPIER
Contents
Specifying a non-standard original size
1
Touch the [Size Input] key.
2
Enter the original size.
(1) Enter the X (horizontal) dimension of the
original.
Touch the X (width) numeric value display key to open a
number entry screen. Enter the width of the original with
the numeric keys, and touch the [OK] key in the number
entry screen. When the document glass is used, enter a
number from 25 mm to 297 mm (1" to 11-5/8").
When the automatic document feeder is used, enter a
number from 89 mm to 356 mm (3-1/2" to 14").
When a number which is from 139 mm (5-3/8") and less is
entered in 2-Sided copy mode, an original cannot be
scanned.
If the horizontal dimension of the original is less than
89 mm (3-1/2"), use the document glass.
(2) Enter the Y (vertical) dimension of the
original.
Touch the Y (height) numeric value display key to open a
number entry screen. Enter the height of the original with
the numeric keys, and touch the [OK] key in the number
entry screen. When the document glass is used, enter a
number from 25 mm to 216 mm (1" to 8-1/2").
When the automatic document feeder is used, enter a
number from 100 mm to 216 mm (4" to 8-1/2").
If the vertical dimension of the original is less than
100 mm (4"), use the document glass.
(3) Touch the [OK] key.
You will return to the base screen.
Make sure that the entered dimensions appear in the
[Original] key.
• When a number from 298 mm to 356 mm (11-3/4" to 14") to the X (horizontal) dimension and a number from 25 mm
to 99 mm (1" to 3-7/8") to the Y (vertical) dimension are entered at the same time, an original cannot be scanned.
• You can also touch the keys to change the number.
None
Original
OK
A5
B5
Size Input
216x343
A4
216x330 16K
216x340
Custom Size
Inch
AB
OK
OK
Cancel
(25~356)
mm
(25~216)
mm
297
X
Y
210
Original
Size Input
(3)(1)
(2)
To Next Page
Loading...
