Sharp SF-2052 - Page 12

10
MAKING COPIES
2
If the number of originals is known, use the ORIGINAL
TO COPY key to select EVEN NUMBER or ODD
NUMBER in the ORIGINAL TO COPY section of the
operation panel, then proceed to step 3. If the number
of originals is not known, select PRE-COUNT
ORIGINALS for an automatic count by the RADF and
press the START key.
●
The following message will appear.
THE NUMBER OF ORIGINALS IS --.
●
When the count is complete and the number is known, replace
the originals in the document feeder tray and select EVEN
NUMBER or ODD NUMBER as above.
3
Enter the desired number of copies.
●
If the specified number of copies is more than 50, the copy
quantity display will display 50 after copying starts. If an
optional sorter is installed, the display will change to 20 after
copying starts (in sort mode).
4
Press the START key.
●
To cancel a copy run during duplex copying, press the clear
( ) key. Incomplete copies will be output from the duplex
tray.
2-sided copies from 2-sided originals
1
Adjust the original guides to the size of the originals
and set the originals face up in the document feeder
tray.
2
Use the ORIGINAL TO COPY key to select .
2
2
USING THE RADF
ORIGINAL TO COPY
EVEN NUMBER
ODD NUMBER
1 1
2
2
2
2
1
(ORIGINALS)
1
PRE-COUNT
ORIGINALS
ODD NUMBER
2
2
2
11
START
123
456
7
8
9
C
0/
AUDIT CLEAR
Using the RADF
PRE-COUNT
ORIGINALS
EVEN NUMBER
ODD NUMBER
2
2
2
11
(ORIGINALS)
PRE-COUNT
ORIGINALS
ODD NUMBER
2
2
2
11