42
Analog Audio Outputs
Eight analog outputs are available for recording, language distribution system, teleconferencing unit, or an external PA
system.
Out A Out B Out C Out D
TCP/IP
Out E
A B C D
Out F Out G Out H
DIS-CCU
Eight Analog Outputs
Select the audio source for each analog output
Go to Audio > Output Control and choose from the following options:
• Group: Eight separate groups for isolating specific microphones. This selection corresponds to the groups configured
from the Group Setup page.
Note: If the group buss is not used for the corresponding XLR output, it is unavailable in the routing matrix.
• Ch. 1 -31: Interpretation channels
• Floor: The audio from all open microphones that are routed to Group A (floor mix). There are three variations on this
mix to chose from:
• Ch. 0: Headphone mix with AGC, useful for sending to an IR language distribution system.
• Floor 1: Loudspeaker mix, useful for sending to a PA or broadcast equipment.
• Floor 2: Loudspeaker mix with volume attenuation (Audio > Loudspeaker Control)
To Next Page
Loading...
