62
Gain can be set to 0 dB or 10 dB. 0 dB will not add any
gain to the line input whereas 10 dB will add 10 dB gain to
the line input.
Line Input 2 Gain
line_input_gain_2 <level><CR>
Indicates the input gain of the line in 2 input.
<gain>: 0 or 10.
Gain can be set to 0 dB or 10 dB. 0 dB will not add any
gain to the line input whereas 10 dB will add 10 dB gain to
the line input.
Line Output Level (A-D)
line_output_level <output> <level><CR>
Adjusts the level of the line output signal.
<output> Indicates which output is being controlled.
Possible values: ‘A’, ‘B’, ‘C’, ‘D’, ‘E’, ‘F’, ‘G’, ‘H’. On DIS-
CCU ‘A’ to ‘D’ are possible. DIS-CCU may deliver ‘A’ to ‘H’.
<level> The level of the line output ranges from -41 to 0.
The value -41 indicates the output is zero. Values from -40
to 0 indicate attenuation in dB.
Define Audio Path
audio_path <path> <on/off><CR>
This command defines audio connections in the system.
<path> Indicates which connection is being controlled.
Possible values are: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A' or
'linein_1_to_floor'.
<on/off> Indicates whether the audio is being routed from
microphones/lineinput_1 to speakers/lineoutput_A/floor.
Individual Speaker Attenuation
mic_speaker_attenuation
<seat_number><attenuation><CR>
Indicates the speaker attenuation of a microphone.
<seat_number>: The desired microphone
<Attenuation>: The desired speaker attenuation. Possible
values: 0 to 7. (0 to 6 will attenuate 0 to 6 dB. 7 is speaker
off.)
Individual Microphone Attenuation
mic_attenuation <seat_number><attenuation><CR>
Indicates the attenuation of a microphone.
<seat_number>: The desired microphone
<Attenuation>: The desired attenuation. 0 to 6 dB, where
0 is the lowest attenuation and 6 is most attenuation.
Audio Status Complete
audio_status_done<CR>
This command terminates audio status streaming.
Voting Commands
Commands from External Control to
the DIS-CCU
Start a voting session
start_voting <voting_session_id><CR>
Starts a voting session in the CCU
<voting_session_id>: Identification of the voting
configuration to start.
The CCU replies with ‘voting_started’, if a voting session is
started.
▪ SW 6000 controlled
The voting_session_id defines which voting configuration
to run. A list of configurations can be requested by
command ‘voting_status’.
If no voting_session_id is specified, the 'default SW 6000
voting configuration' is requested.
▪ Standalone
voting_session_id defines the build-in voting
configurations:
'1’ 3-button voting
'2' 3-button secret voting
'3' 5-button voting
'4' 5-button secret voting
If no voting_session_id is specified, the configuration ‘1’
is requested.
Stop a voting session
stop_voting<CR>
Used to stop an ongoing voting session in the CCU.
If the voting session is stopped, the CCU replies with
voting_stopped.
Cancel a voting session
cancel_voting<CR>
To Next Page
Loading...
