SICK DUSTHUNTER SB30

35
OPERATING INSTRUCTIONS | DUSTHUNTER SB30
8014551/1COY/3-0/
2016-08| SICK
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
Fig. 18: Electronics unit opened
▸ Loosen fastening screws (8) for tube (9) and take the tube off (see “Electronics unit
o
pened”, page 35).
▸ Unscrew mounting ring (10) from the tube, turn it round and screw it back on again.
Fig. 19: Tube with mounting ring
▸ Connect the pins for immersion depth adjustment (11) on the processor board with a
jum
per.



Plug connector

Processor board

Fastening screws

Tube
 

Tube

Mounting ring
CAN-Bus