EasyManua.ls Logo

SICK Flexi Compact - Page 93

SICK Flexi Compact
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Input Description
C1
(opt
ional)
Data type: Boolean
The optional C1 input can be used as additional protection against
manipulation. If it is used, the C1 input must have switched to 0 after a
previous muting cycle, and to 1 at the latest when both muting sensor
signal inputs switch to 1 at the same time. A failure to meet this
condition results in a muting error, which is indicated at the Muting error
output.
The C1 input must then switch back to 0 before the subsequent muting
cycle is permitted. The C1 input is not relevant for the duration of the
muting status.
Table 110: Outputs
Output Description
Enable Data type: Boolean
Muting lamp Data type: Boolean
The Muting lamp output can be used to indicate when a muting cycle is
active.
The Muting lamp output = 0 if the Muting status output = 0
The Muting lamp output = 1 if the Muting status output = 1 or the
Override status output = 1
The Muting lamp output pulsates at 2 Hz if the Override required output
= 1
Muting status Data type: Boolean
The output indicates the status of the muting function.
The Muting status output = 0 if the muting cycle is inactive (no error)
or a muting error has been detected
The Muting status output = 1 if the muting cycle is active (no error) or
override is active (no error)
Override required Data type: Boolean
Muting error Data type: Boolean
"Output Muting error", page 103
Override status Data type: Boolean
Status Data type: Boolean
0 = Er
ror
1 = No error
The value at the output is the inverted value of the Muting error output.
Table 111: Parameter
Parameter Description
Direction detection
Dis
abled
Forward (A1 / A2 first)
Backward (B1 / B2 first)
"Parameter Direction detection", page 104
Condition of the other sen‐
sor pair f
or muting start
Bo
th sensors are free
At least one sensor is free
"Parameter Condition of the other sensor pair for muting start",
page 105
Condition for end of muting
W
ith muting sensor pair
With electro-sensitive protective equipment (ESPE)
"Parameter Condition for end of muting", page 105
CONFIGURATION 7
8024589/2020-11-10 | SICK O P E R A T I N G I N S T R U C T I O N S | Flexi Compact
93
Subject to change without notice

Related product manuals