1. In the project tree, select LD-LRS36xx…, Monitor, Scan view pro.
2. Compare the measurement line with the required result.
NOTE
•
The Pro scan display in the Monitor depends on the available processing power of the
computer and is not a real time display. For this reason not all measured values
are displayed. The same restriction also applies to saving the displayed measured
values in a file.
•
The monitor displays the measured values unfiltered, i.e. the effect of filters
cannot be checked using the monitor.
3. After successful completion of the test measurement, save the configuration per‐
manently in the device: Menu LD-LRS36xx, Parameters, Save permanently.
COMMISSIONING 7
8016506/1G07/2020-11-08 | SICK O P E R A T I N G I N S T R U C T I O N S | LD-LRS
35
Subject to change without notice
To Next Page
Loading...
