8 Maintenance
8.1 Maintenance plan
NOTE
No maintenance is required to ensure compliance with the laser class.
Table 10: Maintenance plan
Maintenance work Interval To be carried out
by
Check device and connecting cables
for damage at regular intervals.
Depends on ambient conditions and
climate.
Specialist
Clean housing and optics cover. Depends on ambient conditions and
climate.
Specialist
Check the screw connections and
plug connectors.
Depends on the place of use, ambi‐
ent conditions or operating require‐
ments. Recommended: At least every
6 months.
Specialist
Check the mounting accessories and
vibration dampers used.
Depends on the place of use, ambi‐
ent conditions or operating require‐
ments. Recommended: At least every
6 months.
Specialist
Check that all unused connections
are sealed with protective caps.
Depends on ambient conditions and
climate. Recommended: At least
every 6 months.
Specialist
8.2 Cleaning
NOTICE
Equipment damage due to improper cleaning.
Improper cleaning may result in equipment damage.
■
Only use recommended cleaning agents and tools.
■
Never use sharp objects for cleaning.
b
Clean the optics cover at regular intervals and in the event of contamination with
a lint-free lens cloth (part number 4003353) and plastic cleaning agent (part
number 5600006). Rinse off coarse dirt first with water. The cleaning interval
essentially depends on the ambient conditions.
NOTICE
If the optics cover is scratched or damaged (cracked, broken), it must be replaced.
Contact SICK Support to arrange this.
■
If the optics cover is cracked or broken, take the device out of operation immedi‐
ately for safety reasons and have it repaired by SICK.
8 MAINTENANCE
36
O P E R A T I N G I N S T R U C T I O N S | LD-LRS 8016506/1G07/2020-11-08 | SICK
Subject to change without notice
To Next Page
Loading...
