SICK VMS4200 User Manual (English)

Other manuals for SICK VMS4200

Questions and Answers:

B
Brian RichAug 4, 2025
What to do if the LED does not light up on my SICK GPS?
- J
  Jonathan EvansAug 4, 2025
  If the LED on your SICK GPS isn't lighting up, it could be due to a few reasons. First, check if something is blocking the beam's path and remove the obstruction. Next, ensure the photoelectric sensor is properly aligned with the reflector; if not, readjust it. Also, verify that the S1 signal ground switch is set to GND. Make sure all wires are correctly attached in the terminal block. If none of these steps work, the photoelectric sensor might be defective and need replacement.
G
George BakerAug 14, 2025
What to do if LEDs do not flash on my SICK VMS4200?
- M
  mccarthymelissaAug 14, 2025
  If the LEDs on your SICK GPS aren't flashing, several factors could be at play. Initially, confirm there's sufficient contact between the measuring wheel and the conveyor belt. If the measuring wheel appears worn, consider replacing it. Also, ensure the S2 signal ground switch is set to GND. Check that all wires are correctly attached in the terminal block. If these steps don't resolve the issue, the encoder might be defective, requiring replacement.
C
christina46Aug 25, 2025
Why is the LED on my SICK VMS4200 GPS lighting up brightly?
- K
  kjonesAug 25, 2025
  If the LED on your SICK GPS lights up brightly like the others, it might indicate a wiring issue. Ensure the sensors are correctly connected to the CAN bus. Also, verify that the wires are correctly attached in the terminal block. If the problem persists, the terminator might be defective and need replacement.

SICK VMS4200 Specifications

General

Brand	SICK
Model	VMS4200
Category	GPS
Language	English

SICK VMS4200 Addendum To Operating Instructions

Table of Contents

Other manuals for SICK VMS4200

Questions and Answers:

SICK VMS4200 Specifications