SICK VMS4200

2 FOR YOUR SAFETY
8
8026364 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4200/5200
Subject to change without notice
2 For your safety
2.1 Intended use
The VMS4200/5200 multi-dimensional measurement system is used to measure cubic
and irregularly-shaped objects on flat conveying systems in industrial environments.
The objects to be measured must be dimensionally stable, opaque, and non-reflective.
The two LMS4x21 2D LiDAR sensors are mounted horizontally above the conveying
technology and typically rotated at an angle of 45°.
The VMS4200/5200 determines the length, width and height. These dimensional values
can be used to calculate the volume of the smallest rectangular box that fully encloses
the object.
The measurement results can be transferred to the customer network via the data
interface of the SIM2000-2 Prime controller.
The VMS5200 multi-dimensional measurement system can be verified as legal for trade
and, after a successful MID conformity assessment, used for billing purposes.
NOTE! Intended use also includes observance of these supplementary operating
instructions, in particular the safety notes and repair and maintenance requirements as
well as proper installation, in particular for billing operation.
2.2 General safety notes
▸
Please read this document through carefully and observe all the safety notes and
information before working on the multi-dimensional measurement system.
▸
Only qualified persons from the relevant departments are permitted to work on the
multi-dimensional measurement system.
▸
Follow operating processes.
▸
Follow local regulations.
▸
Follow all local regulations relating to working with electrical components.
• Only authorized persons are permitted access to the multi-dimensional measurement
system.
System damage/transport damage
Damage to the individual components can lead to malfunctions of the system as a whole.
▸
Do not ignore any damage caused to system components during transport.
▸
In case of damage, contact SICK Service.