4 MOUNTING
8026364 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4200/5200
Subject to change without notice
4 Mounting
All transport, assembly, mounting, and electrical installation work must only be carried out
by qualified persons.
• Qualified persons have the specialist training, skills, experience and knowledge of the
relevant regulations and standards needed to be able to perform work assigned to
them and to identify and avoid any potential dangers independently.
• Electricians have the professional training, skills, experience and knowledge of the
relevant standards and provisions needed to work on electrical systems and to detect
and avoid any potential dangers independently.
4.1 Mounting 2D LiDAR sensors
4.1.1 Overview
Fig. 47: Mounting the 2D LiDAR sensors
Legend
1 Telescopic rod with adjuster via defined wells
2 Components of the attachment mechanism for mounting the modular
bracket on the frame
• Mounting plate
• Spring plate
3 Mounting plates for mounting the LMS4x21 2D LiDAR sensors
To Next Page
Loading...