6 COMMISSIONING
8026364 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4200/5200
Subject to change without notice
6.2.4 Opening the configuration interface
▸
Click the Offline button in the tile (opens the LMS4x21 in this example).
▸
Synchronize the 2D LiDAR sensor’s device data with the device data of the SOPAS
project. To do this, click on Read parameters.
▸
The standard parameters are transmitted from the 2D LiDAR sensor into the SOPAS
project. These parameters are then adapted to the requirements of the 2D LiDAR
sensor in SOPAS.
Online appears in the tile. The LED lights up green.
Bringing the
device online
To Next Page
Loading...