6 COMMISSIONING
8026364 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4200/5200
Subject to change without notice
6.2 Configuring the system with SOPAS
The measurement system is adjusted by configuring the measuring conditions on site.
This enables measurement, analysis, and output properties to be parameterized as
required.
The SOPAS ET configuration software (included) allows interactive configuration. You can
use the software to parameterize and test the properties, analysis behavior, and output
properties of the system as required.
6.2.1 Connecting the configuration PC
The SOPAS configuration software is installed on a computer, which is connected to a free
port on an Ethernet switch of the TTC100-2 via an Ethernet cable.
The configuration software is available for download from the SICK home page.
Fig. 63: Establishing the configuration PC – SIM2000-2 Prime controller connection
▸
Using an Ethernet cable, connect the configuration PC to a free Ethernet port on an
Ethernet switch of the TTC100-2.
To Next Page
Loading...