Siegenia GENIUS 2.2 - Default Chapter; Table of Contents

3/44

GENIUS 2.2, Electromechanical mul-point lock
3/4402.2020H39.ELEKS013EN-00

1 ABOUT THIS DOCUMENTATION4
1.1 Target group .................................................. 4
1.2 Product descripon ....................................... 4
1.3 Producer ........................................................ 4
1.4 Dimensions ................................................... 4
1.5 Applicable documents ................................... 4
1.6 Symbols used ................................................ 4
2 SAFETY5
2.1 Required knowledge and capabilies of
the target groups .......................................... 5
2.2 Intended use ................................................. 5
2.3 Transport ....................................................... 5
2.4 Protecve equipment ................................... 6
2.5 Safety notes .................................................. 6
2.6 Structure of the warning notes ..................... 6
2.7 Warning notes used ...................................... 6
2.8 Foreseeable improper use ............................ 7
3 COMPONENTS AND VARIANTS9
3.1 Size variants and dimensions ...................... 10
3.1.1 Dimensions of the main lock cases ............. 11
3.1.2 Dimensions of the auxiliary boxes .............. 13
4 FUNCTIONS14
4.1 Connecons and operang elements
GENIUS 2.2 (EA / CA) ................................... 14
4.2 Connecons and operang elements
GENIUS 2.2 (EB / CB) ................................... 15
4.3 Cable and wiring diagram ........................... 16
5 INSTALLATION19
5.1 Installaon condions and requirements ... 19
5.2 Screw recommendaons ............................ 19
5.3 Assembly of sash side ................................. 20
5.3.1 Change DIN orientaon of the latch ........... 20
5.3.2 Milling the door leaf .................................... 21
5.4 Roung and connecng cables ................... 23
5.4.1 Via the SI-BUS connecon ........................... 23
5.4.2 Via the analogue connecon ...................... 24
5.5 Screwing on the mul-point lock ................ 26
6 FRAME SIDE ASSEMBLY27
6.1 Milling the frame ......................................... 27
6.2 Assembling the frame parts and magnet .... 28
6.2.1 Variants of magnet ...................................... 28
6.2.2 Mounng the striker plates in PVC and
aluminium frames ....................................... 29
6.2.3 Mounng the striker plates in mber
frame ........................................................... 30
6.2.4 Mounng the locking rail ............................ 31
6.2.5 Adjustment of the airgap ............................ 32
6.2.6 Adjustment of the AT piece ......................... 33
6.2.7 Correct the Q adjustment ........................... 35
7 FUNCTIONAL TEST37
7.1 Check the locking and opening of the door 37
7.2 Check the electromechanical locking and
release ......................................................... 37
7.3 Check the funconing of the oponal
access control system .................................. 38
7.4 Troubleshoong .......................................... 38
7.4.1 Malfuncon of the lever handle ................. 38
7.4.2 Malfuncon of the prole cylinder ............. 38
7.4.3 Malfuncon of the magnec sensor ........... 38
7.4.4 Malfuncon due to block movement ......... 38
7.5 Lubricaon .................................................. 38
7.6 Manual adjustment of the magnec
sensor on GENIUS 2.2 ................................. 39
7.7 Technical specicaons ............................... 41
8 DISPOSAL42
9 EC DECLARATION OF INCORPORATION 43