Siegenia GENIUS 2.2 - Safety Information; Required Skills and Knowledge; Intended and Prohibited Use

5/44

GENIUS 2.2, Electromechanical mul-point lock
5/4402.2020H39.ELEKS013EN-00
2 
 

We assume and require that fabricators possess the
following knowledge and skills:
• knowledge of the regulaons concerning occupa-
onal safety and accident prevenon
• comprehension of technical correlaons according
to state-of-the-art science and technology
• knowledge of professional work steps
• knowledge of the applicable standards and direc-
ves
• knowledge of applicable tesng regulaons
• knowledge and skills with regard to material pro-
cessing of the respecve material (mber, PVC,
aluminium)
• knowledge and skills with regard to the professional
use of tooling, machines and systems for the pro-
ducon of door elements
• knowledge and skills with regard to the professional
xing of technical elements
• knowledge in funconal tesng and operaon of
door elements
• knowledge of the requirements of prole system
providers
If the door elements are equipped with an electrome-
chanical drive, the following knowledge and skills are
presumed and required:
• knowledge and skills with regard to the professional
fabricaon of electrical components
We assume and require that ers and retroers
possess the following knowledge and skills:
• knowledge of the regulaons concerning occupa-
onal safety and accident prevenon
• comprehension of technical correlaons according
to state-of-the-art science and technology
• knowledge of professional work steps
• knowledge of the applicable standards and direc-
ves
• knowledge and skills with regard to the professional
use of electrical and mechanical tooling
• knowledge and skills with regard to the professional
xing of technical elements
• knowledge and skills with regard to the retrot of
mechanical security technology on window or door
elements
If the door elements are equipped with an electrome-
chanical drive or a sensor, the following knowledge and
skills are presumed and required:
• knowledge and skills with regard to the professional
fabricaon of electrical components
• knowledge and skills with regard to the work steps,
connecng electrical components, commissioning
and funconal tesng
KFV oers training courses for the acquision of some
of the required knowledge and skills. Contact your KFV
sales consultant in case of requirement.
 
• The GENIUS 2.2 is suitable for installaon in mber,
aluminium, steel and PVC entrance doors.
• Use the GENIUS 2.2 as shown below:
– with a non-restricve cylinder in accordance with
DIN 18252 and the designaon „FZG“
– in vercal installaon
– in a technically sound condion
– only with original KFV products and accessories
• Do not use the GENIUS 2.2 as shown below:
– for escape doors in accordance with EN 179 or
EN 1125
– in doors for wet rooms or rooms in which the air
contains aggressive or corrosive components
• Do not interfere with and/or make any modica-
ons to the GENIUS 2.2.
• Foreign objects and/or materials which impede or
prevent proper use must not be placed within the
opening range, the locking system or the striker
plates.
• Locking elements must not be misused to hold the
door open.
 
• The transit support provided must remain in the
main lock during the transport of a pre-assembled
door without cylinder lock.
• In the installed and non-installed status of the mul-
-point lock, ensure that the locking elements are in
the release posion.
• Mul-point locks are sensive components and
must therefore be handled with care. For example,
they must not be thrown, hit hard or bent.
• Do not carry the door by the lever handle or hard-
ware when transporng it.