Commissioning
6.4 Making settings in the selected parameter set
3RW44 soft starters
Manual, 03/2017, NEB535219502000/RS-AB/008
101
Activating the fieldbus interface (PROFIBUS DP/PROFINET IO)
For activation of the fieldbus interface, see chapter Activating the PROFIBUS DP
communication module (fieldbus interface) and setting the station address (Page 156).
PROFIBUS DP is shown in the example:
Note
If the "Parameters disabled CPU/Master" parameter is set to "Off" (factory sett
ing), the
parameters set on the soft starter will be overwritten with the values stored in the GSD file or
in the OM when the bus is started. If this is not desired, the parameter must be set to "On".
To Next Page
Loading...
