PROFIBUS DP communication module
9.4 Activating the PROFIBUS DP communication module (fieldbus interface) and setting the station address
3RW44 soft starters
Manual, 03/2017, NEB535219502000/RS-AB/008
157
Activating the PROFIBUS DP communication module via the display, setting
the station address and saving the settings
1. During first commissioning of the soft starter, you must run through the Quick Start menu
(refer to chapter Switching on for the first time (Page 50)). See also SIRIUS
3RW442/443/444/445/446 soft starter operating instructions
(https://support.industry.siemens.com/cs/ww/en/view/21189750) (article number:
3ZX1012-0RW44-0AA0).
2. Press the designated button on the device.
3. The "BUS" LED flashes red.
To Next Page
Loading...
