Commissioning
6.4 Making settings in the selected parameter set
3RW44 soft starters
90 Manual, 03/2017, NEB535219502000/RS-AB/008
Note
An input action can only be modified when the relevant input is not active.
If the same action is assigned to two different inputs, both of the inputs must also be
controlled to carry out the selected function (e.g. to obtain logical "AND" linking for a start
command, assign the "Motor CW PS1" function to both inputs 1 and 2. A start command is
accepted only if both inputs are active).
If the soft starter is switched off via a motor protection or inherent device protection tripping,
the action cannot be acknowledged using the "Trip Reset" function until the displayed
cooling time has expired.
To Next Page
Loading...
