Siemens ADVIA LabCell - Page 102

118 pages

To Next Page

To Previous Page

Symbols Centrifuge Module Interface Operating Instructions

page 102 092D0001-02 Rev. A

The following illustration provides the safety labels locations on the

Centrifuge module Robot assembly.

Figure 13: Centrifuge Module Robot Assembly View

Main Page

Table of Contents3
Introduction7
Hardware Overview7
Hettich Unit9
Robot Assembly12
Drive Unit13
Robot Computer13
Interface Computer13
Cassettes14
Scale14
Universal Power Supply (UPS)15
Status Beacon16
Decapper Module17
Software Overview18
Linemaster Computer Workspace Application18
Centrifuge Operations Screens19
Router Software28
Operating Sequence28
System Operation35
End of Day Procedures35
Turning the Centrifuge Module on35
Monitoring the Centrifuge Module39
Turning the Centrifuge Module off40
Processing Samples Using 2 or 4 Cassettes41
Routing Samples to the Centrifuge41
By LIS Code Tab42
By Sample Type Tab43
By Location Tab44
Location Override Tab45
Usage Tab46
Maintenance47
Cleaning the Centrifuge Module47
Cleaning the Robot Gripper47
Cleaning the Scale50
Cleaning the Cassettes51
Cleaning the Interface Gate Tube Holder53
Maintaining the Hettich Unit55
Accessing the Hettich Unit56
Routine Cleaning of the Hettich Unit59
Re-Installing the Hettich Unit65
Calibrating the Speed of the Hettich Unit Rotor66
Resetting the Counters67
Troubleshooting69
Using the Events Screen69
Emergency Shutdown Procedure70
Recovering from a Total Emergency Shutdown71
E-Stop Conditions72
Lifting the Robot from the Hettich Unit72
Using the Z-Up Feature to Raise the Robot74
Recovering from an E-Stop75
Recovering from a Loss of Power76
Recovering from a Disabled Centrifuge Module77
Removing a Sample Tube from the Robot Gripper78
Managing Sample Tube Breakage80
Detecting a Broken Tube by Cassette Weight80
Detecting a Missing Tube by Survey80
Removing a Broken Tube81
Processing Missing Sample Tubes81
Cleaning after Sample Tube Breakage82
Appendix A: Safety Information83
Protecting Yourself from Biohazards83
References84
Protective Covers, Doors, and Panels85
Mechanical Safety85
Electrical Safety86
Laser Safety87
Appendix B: Warranty and Support Information89
Contact Information89
Siemens Authorized Representative89
Addresses89
Appendix C: Specifications91
Centrifuge Module Specifications91
Hettich Unit Specifications91
Sample Tube Specifications92
UPS Specifications93
Conformance94
Appendix D: Symbols95
System Specific Symbols95
On-System Labels99
Appendix E: Glossary103

Siemens ADVIA LabCell - Page 102

Table of Contents

Related product manuals