Introduction Centrifuge Module Interface Operating Instructions
page 18 092D0001-02 Rev. A
Software Overview
The automation system uses these software applications:
• LineMaster computer workspace application
• Router computer software application
LineMaster Computer Workspace Application
The LineMaster computer communicates with all instruments and modules
and displays the active status of each instrument and module in the
workspace window. The LineMaster computer workspace also reports
instrument events, tube status, and automation system status.
Operations and States Panels
To access the Centrifuge Operation and States panels, select the
Centrifuge station button.
Note For automation systems with more than 1 Centrifuge module
connected, each Centrifuge station button provides access to information,
events, and data for the selected Centrifuge only.
For complete descriptions of the States panel and operational states, see
the ADVIA Automation Solutions Operator’s Guide.
ADVIA LabCell States Panel Buttons
The States panel displays 3 buttons:
•Online
•Offline
• Shutdown, only available on the LabCell system
A white button indicates state is active.
For more information about the States panel, see the
ADVIA Automation Solutions Operator’s Guide.
ADVIA WorkCell States Panel Buttons
The States panel displays 2 buttons for the track and all 3 buttons for the
Centrifuge:
•Online
•Offline
A white button indicates state is active.
For more information about the States panel, see the
ADVIA Automation Solutions Operator’s Guide.
To Next Page
Loading...
