Centrifuge Module Interface Operating Instructions Safety Information
092D0001-02 Rev. A page 85
Protective Covers, Doors, and Panels
The Centrifuge module covers, doors, and panels are designed to protect
you from potential injury from moving parts or exposure to potential
electrical or laser hazard.
Note Close all access doors before operating the Centrifuge module.
Sensors on the access doors prevent the Centrifuge module from operating
if a door is open.
Mechanical Safety
Several primary areas on an ADVIA LabCell or ADVIA WorkCell CDX system
contain potential mechanical hazards:
• Robots on the following instruments or modules:
○ Sample Manager
○ Centrifuge module
○ Dual ADVIA Hematology interface module
○ Stago STA-R interface module
• Pneumatic hose inside the Centrifuge module.
• Divert and interface gates, protected by the track covers.
• Main track and side tracks, protected by the track covers.
WARNING
Do not remove any covers from the Centrifuge module during normal
operation without first contacting your local technical support provider,
unless instructed to do so in these operating instructions. Removing
covers may expose you to mechanical, electrical, biohazard, or laser
hazard that could cause bodily injury to you or could cause damage to the
automation system.
WARNING
Do not attempt to move or remove the Centrifuge module without first
contacting your local technical support provider. Moving or removing the
Centrifuge module without the supervision of a technical support
provider could result in injury and the loss of warranty coverage. If you
need to move or remove the Centrifuge module for any reason, contact
your local technical support provider.
To Next Page
Loading...
