Introduction Centrifuge Module Interface Operating Instructions
page 16 092D0001-02 Rev. A
The Centrifuge module tracks the amount of backup power available.
When there is only 30% power remaining, a message displays on the
LineMaster event log indicating the low battery. Other event messages
provide status of the Centrifuge module when it is running on battery
power.
The following table lists UPS messages that appear in the event log:
Table 1: Event Log UPS Messages
For additional information, refer to the Uninterruptible Power Supply
manual included with the Centrifuge module.
Status Beacon
The Status Beacon illuminates when the E-stop button is pressed or when
the system initiates an E-stop condition. When the beacon is illuminated, it
provides a visual indication that the Centrifuge requires operator attention.
Event Log Messages Descriptions
On battery The Centrifuge module is running on UPS
battery power.
On bypass mode The Centrifuge module is running in
bypass mode.
Battery power remaining The percentage of battery power
remaining.
Low battery The amount of remaining battery power
is below the threshold.
To Next Page
Loading...
